Archive for April, 2018

1) Install a minimal 64-bit Debian 9 Stretch. Create a regular user "toor".
2) # Make sure CD-ROM is commented out in "/etc/apt/sources.list", and that you have configured an official Debian mirror there. Also make sure "contrib" is configured to your Debian mirror. As root:
apt-get -y update
apt-get -y upgrade
apt-get -y install net-tools openssh-server openssh-client
3) cp -p /etc/network/interfaces /etc/network/interfaces.orig
vi /etc/network/interfaces # Have the following contents. You may modify the contents if necessary.
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).

source /etc/network/interfaces.d/*

# The loopback network interface
auto lo
iface lo inet loopback

# The primary network interface
allow-hotplug enp3s0
#iface enp3s0 inet dhcp
› Continue reading...

Note 1: It is assumed that the IP of your Debian 9.4 64-bit KVM server is 192.168.1.160. Change this if necessary.
Note 2: It is assumed that the gateway IP of your Debian 9.4 64-bit KVM server is 192.168.1.1. Change this if necessary.
Note 3: It is assumed that the broadcast IP of your Debian 9.4 64-bit KVM server is 192.168.1.255. Change this if necessary.

Setup server for remote access:
1) Install minimal Debian 9.4.0 64-bit. Create a regular user "toor".
2) Remove installation media.
3) # Make sure CD-ROM is commented out in "/etc/apt/sources.list", and that you have configured an official Debian mirror there. Also make sure "contrib" is configured to your Debian mirror.
apt-get -y update
apt-get -y upgrade
apt-get -y install net-tools openssh-server openssh-client
4) vi /etc/network/interfaces # Have the following contents. You may modify the contents if necessary.
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).

source /etc/network/interfaces.d/*

# The loopback network interface
auto lo
iface lo inet loopback

# The primary network interface
allow-hotplug enp3s0
› Continue reading...

Setup Cisco RV325 for Cisco Easy VPN client and Shrewsoft VPN client (full VPN)
# Source: https://supportforums.cisco.com/video/12300166/rv320-and-rv325-ipsec-vpn-client-configuration
1) Login to router.
2) Click "VPN".
3) Click "Client to Gateway".
4) Tick "Easy VPN".
5) Set "Tunnel Name" to "fullvpn". This is also your group name.
6) Disable "Minimum Password Complexity".
7) Set "Password" to a desired password (for this documentation, it is "DoNotUseThisExample". PLEASE USE YOUR OWN DIFFERENT PASSWORD!).
8) Set "Interface" to "WAN1". We'll use WAN1 for VPN access here.
9) Make sure "Enable" is ticked.
10) Set "Tunnel Mode" to "Full Tunnel"
11) "IP Address" should be "192.168.1.0". If you use a different value from the default 192.168.1.0, please use it instead.
12) "Subnet Mask" should be "255.255.255.0".
13) "Extended Authentication" should be "Default - Local Database".
14) Click "Save".

Create an user on Cisco RV325 for Cisco Easy VPN
# Source: https://supportforums.cisco.com/video/12300166/rv320-and-rv325-ipsec-vpn-client-configuration
› Continue reading...

Back to top